Contact

Contact Merlin

Contact us

Audiova Conduction Headphones FAQ

Dyun Viray posted this on Jan 21, 2015
Q) How to Charge?
A) Connect the headphone to your PC via the Micro USB Cable attached in the package. The headphone will be fully charged in 3 hours. The LED indicator show in red during charging, and turns into blue when fully charged. Note: 1. It is strongly recommended to fully charge the headphone before the first time use. 2. The headphone is not workable during charging. 3. It is recommended to charge once each month to extend the battery life if you don’t use it for long time.
Q) Bluetooth Pairing?
A) 1. Slide the Power Switch to the “ON” position. 2. In the Bluetooth settings of your mobile phone or other device with Bluetooth function, search for Bluetooth devices, and select “Bluetooth headphone”. ¬If it’s the first time pairing, the headphone will enter the pairing mode automatically. The LED indicator will flash in blue and red. The headphone will automatically re¬pair with a device that was previously paired in approximately 18 seconds. The LED indicator will flash in blue when paired. ¬If the headphone pair with other mobile phones, press and hold “play” button for 5 seconds, it will enter into manual pairing mode. LED indicator will flash between blue and red alternately. Attention: 1. If out of range while connected to a device (more than 33 feet/10 meters). The headphone will disconnect from the device. Once it’s back within the valid range, it will reconnect automatically. However, if the headphone is disconnected for a long time (more than 3 minutes), you may need to press any button on the headphone, to reconnect the device. 2. If the paired device is turned off while connected to the headphone, it will disconnect. When you turn on the device again, just press any button on the headphone to reconnect.
Categories: Knowledge Base FAQ's
Support